Use with HF scientific M100+ and Micro 100 laboratory NTU meters.
The Pour Through Assembly consists of a a cylinder with integrated directional injection feature, an NTU measurement cuvette, a 1/4” NPT x 1/4” OD push to connect fitting, drain tubing and a dust cover. We also offer an optional benchtop stand to keep the assembly upright on the bench top when it is not in use.
Install the pour through assembly in the optics of the laboratory turbidimeter and, if appropriate, index it according to the turbidimeter instructions. Ensure the drain tube is properly routed to the drain. Remember the key to consistency is following the same procedure for each measurement.
Flush with DI or distilled water between measurements.
